Juice beverage production equipment is divided into 4000 bottles/hour, 6000 bottles/hour, 10000 bottles/hour, 15000 bottles/hour, 20000 bottles/hour-36000 bottles/hour according to different output. Plastic bottles generally use plastic caps. Glass bottle juice beverages generally use easy-to-pull ring caps, three-screw caps, etc. Let’s talk about the key points of three-screw caps, which can be in the form of rubbing caps, but now a three-in-one machine is generally used, which directly caps. After the glass bottle is hot-filled, the cap is automatically put on, and a reverse capping device is installed to make the three-screw cap fall to the correct position, and then perform the normal capping operation to ensure that the capping is in place, and the bottle mouth will not be screwed or screwed. The phenomenon that the cover is not in place. A spray cleaning device needs to be installed between filling and capping. Through photoelectric detection, when a bottle passes through, pure water is sprayed on the bottle mouth, and the juice beverage remaining at the screw mouth of the bottle mouth during filling is sprayed clean. To avoid the subsequent growth of bacteria on the bottle mouth. From a strict safety point of view, after the fruit juice beverage is sealed, it needs to be inverted for sterilization and spray sterilization and cooling, which is also called secondary sterilization. The inverted bottle mainly uses the temperature of the juice beverage to sterilize the inside of the bottle cap. Spray sterilization is also called pasteurization, and then the temperature is immediately lowered. The long-term high temperature of the juice material will cause the loss of internal influence components, affecting the taste and color.
After the juice beverage production equipment is used, it needs to be cleaned regularly. The CIP cleaning system is used, and the cleaning operation Filter material cleaning: after charging, clean the filter material by backwashing: open the water supply valve, and then open the backwash valve to enter the water. This process generally requires For a few hours, until the water is clear, pay close attention to the filter material with a large number of normal particles in the drainage when cleaning, otherwise, the water inlet valve should be closed immediately to prevent the filter material from rushing out. Positive washing and running: After the filter material is cleaned, open the lower discharge valve and enter the normal state. The flushing materials used are: acid liquid, lye liquid. Sanitizer, hot water.
Post time: Jun-16-2022